Filter
Top Products
11
Changing the Wash Program / Cycle:
If at any time during the washing process you would like to change the selected wash program / cycle;
follow the steps below:
a) Press and hold the START / RESET button for approximately 3 seconds.
(The START / RESET indicator light will be ON indicating that the unit is in PAUSE mode.)
b) Select the new wash program / cycle by turning the selector knob to the appropriate program /
cycle.
c) Press the START / RESET button again, the dishwasher will resume operation using the newly
selected wash program / cycle.
NOTE:
If you change the wash program / cycle after the detergent has been dispensed or the dishwasher has
already drained the wash water, you will need to refill the detergent dispenser for the newly selected
program / cycle accordingly. (See the section “Proper Use of Detergent on page 13)
At the End of the Wash Cycle
Once the dishwasher has completed the selected wash cycle / program, there will be a buzzer sound for 8
seconds indicating the end of the cycle and then stop.
a) Shut off the water supply.
b) Turn the dishwasher OFF by pressing the ON/OFF button.
c) Slightly open the door with caution to allow any residual steam to escape.
d) Wait a few minutes (approximately 15 minutes) before unloading the dishwasher as the dishes
and cutlery will be hot. This also allows the dishes not only time to cool down but also aids in
drying.
e) Unload the dishwasher and store your dishes and cutlery as normal.
f) The interior of the dishwasher will be wet, this is normal and will dry naturally.
WARNING:
It is dangerous to open the door when washing, because the hot water may scald you.
Check the Water Temperature
For the most effective cleaning and to prevent damage to the dishes being cleaned, the water supplied to
the dishwasher should be at a temperature of at least 120ºF (49ºC) and no more than 150ºF (66ºC).
Using a candor or meat thermometer, place the thermometer in a glass under the faucet that will be used
for the dishwasher and allow the HOT water to continuously run and fill the glass. Once the temperature
stops rising this is the highest temperature of the water from that faucet.