Filter
Top Products
Gourmet Oven Operation
8
Turning the Oven “On”
1. Plug the oven power cord into a receptacle supplying power that matches that specified on the
nameplate. The mating receptacle for the GO-36 plug is a NEMA style 6-20. The mating
receptacle for the GO-36T plug is a NEMA style 6-30.
2. Place the POWER ON/POWER OFF rocker switch in the POWER ON position.
Programming the Oven
Press and hold the “START/STOP” button until display alternates between “STOP” and the probe sense
temperature. The control is now ready for programming.
Setting the Preheat Temperature
Press the “SELECT” button until the “PREHEAT TEMP” light turns on. Press the “UP” or “DOWN” buttons
to obtain the desired temperature. If a preheat cycle is not required, press the “UP” or “DOWN” buttons
until “OFF” is displayed. “OFF” is displayed below 100° F. or above 400° F.
Setting the Cook Temperature
Press the “SELECT” button until the “COOK TEMP” light turns on. Press the “UP” or “DOWN” buttons
until the desired temperature is displayed.
Setting the Cook Time
Press the “SELECT” button until the “COOK TIME” light turns on. Press the “UP’ or “DOWN” buttons until
the desired time is displayed. To disable the cook function, press the “UP” or “DOWN” button until “OFF”
is displayed. “OFF” is displayed below 100° F or above 400° F.
Setting the Hold Temperature
Press the “SELECT” button until the “HOLD TEMP” light turns on. Press the “UP” or “DOWN” buttons until
the desired temperature is displayed. The hold function can be disabled by pressing the “UP” or “DOWN”
buttons until “OFF” is displayed. “OFF” is displayed below 100° F. or above 250° F.
Pressing the “SELECT” button again returns the control to the “STOP MODE”. The display will alternate
between “STOP” and the probe sense temperature. The control is ready for cooking.
Cooking
1. Press the “START/STOP” button.
• If a pre-heat temperature was programmed, the “CYCLE ON” light will turn on, the display will
alternate between “PrE” and the probe temperature and the controller will elevate the oven
temperature to the pre-heat value. When the oven temperature reaches the desired pre-heat
value, the “CYCLE ON” light begins flashing and a (5) second pulsing audible alert will be
activated. The control will maintain the oven temperature until the product is loaded into the
oven.
• If pre-heat temperature was turned off, the oven will immediately enter a cook/hold mode.
2. Load product into the oven.
3. Press the “START/STOP” push button. The controller will now regulate the oven to the desired
cook temperature and the cook timer will count down. The “CYCLE ON” light will be on and the
display will alternately show oven temperature and cook time remaining.