Filter
Top Products
Gas Pressure Fryer Operation
19
Table 1. System Programming Procedure
STEP ACTION DISPLAY COMMENTS
1 Press the FILTER/OFF/FRY
switch to FRY.
LOW
2 Press PROG on the keypad. PROGRAM CODE
3 Input 1712 and ENTER. PROGRAM SYSTEM
4 Press ENTER. PROGRAM DEGREES
°F
This command allows you to
choose the temperature scale
option you want to use. The display
will show either show °F or °C.
5 Press TOGGLE/CLEAR until the
desired option is displayed.
PROGRAM DEGREES
X
X refers to the temperature scale
you have chosen.
6 Press ENTER. PROGRAM APL TYPE
GAS
This command allows you to
choose the appliance type you are
using. The display may show
ELECTRIC, GAS OR ALF.
7 Press TOGGLE/CLEAR until the
desired option is displayed.
PROGRAM APL TYPE
X
X refers to the appliance type you
have chosen.
8 Press ENTER. PROGRAM MELTCYCL
YES
This command allows you to set
the melt cycle option. This is
normally set to yes if you are using
solid shortening. The display will
show either YES or NO.
9 Press TOGGLE/CLEAR until the
desired option is displayed.
PROGRAM MELTCYCL
X
X refers to the melt cycle option
chosen.
10 Press ENTER. PROGRAM GLBLFLTR
0
This command allows you to
specify the total number of fry
cycles to complete among all
product programs before a
message is displayed reminding
you to filter the shortening (filter
lockout).
11 Press TOGGLE/CLEAR and
input the number of fry cycles
you want to complete among all
product programs before
enabling filter lockout.
PROGRAM GLBLFLTR
X
X refers to the number of program
cycles you want to complete
among all product programs before
filtering the shortening.
12 Press ENTER. PROGRAM SYSTEM
13 Press PROG to exit the
programming mode.
LOW