Filter
Top Products
7 / 11 ENHood / User Manual
3.1 Drilling the Support surface and
Fitting the Hood
Screw Fitting
• The hood support surface must be 135 mm
above the bottom surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided.
• Cut a hole ø 150 mm in size on the support
surface, using the drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provi-
ded.
3 Installation
Snap-On Fitting
• The hood can be installed either directly on the
bottom surface of the wall units using snap-on
side supports.
• Cut a fitted opening in the bottom surface of the
wall unit, as shown.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.
Hood Type CTB 6250 XA CTB 9250 XA
L1 510 810