Filter
Top Products
8
GB
Warning
This appliance must be
earthed
If the tted moulded plug is not suitable
for your socket, then the plug should
be cut off and an appropriate plug
tted.
Destroy the old plug, which is cut off as
a plug with a bared cord could cause a
shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the
fuse need to be replaced an ASTA
approved BS1362 fuse of the same
rating must be used. Do not forget
to ret the fuse cover. In the event of
losing the fuse cover, the plug must
not be used until a replacement fuse
cover has been tted. Colour of the
replacement fuse cover must be the
same colour as that visible on the
pin face of the plug. Fuse covers are
available from any good electrical
store.
Important
Fitting a different plug
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals on your plug,
proceed as follows:
1. Connect the green - yellow or
green (earth) wire to the terminal
in the plug marked ‘E’ or with the
symbol or coloured green
and yellow or green.
2. Connect the blue (neutral) wire to
the terminal in the plug marked ‘N’
or coloured black.
3. Connect the brown (live) wire to
the terminal in the plug marked ‘L’
or coloured red.
With the alternative plugs a 13A fuse
must be tted either in the plug or
adaptor or in the main fuse box. If in
doubt contact a qualied electrician.
Electrical requirements
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
If the supply cord or the mains lead
is damaged please do not replace
it by your own. The supply cord or
the mains lead must be replaced by
a Beko Authorized Service Agent
personnel or a similarly qualied
person.