Filter
Top Products
EN
11
1. Switch off at the socket outlet and
pull out the mains plug.
2. Remove all food, loose items and
fittings from inside the appliance and
door shelves.
3. Carefully tilt the appliance on its back
side. (1) (You may need somebody to
help you.) Take care not to damage
the appliance by laying on some
protective material (e.g. its original
packaging). Make sure that you
tilt the appliance on its back side,
otherwise compressor oil may block
the pipes and you may damage the
appliance.
4. Unscrew and remove the LHS front
feet and bolt (2).
5. Unscrew the bolts and remove the
bottom hinge while holding the door
(3).
6. Remove the door carefully from the
top hinge by sliding down wards (4).
7. Reposition top hinge bushing and
blanking plug on the opposite side
and stand the door safely (5). You
may find it easier to remove the
bushing and the plug with the tip of
a small screwdriver. Take care not to
mark the door.
8. Reposition the top hinge on the
opposite side (6 and 7).
9. To refit the door, locate the top hinge
in the door, attach to the cabinet and
hold the door (8).
10. Fit the bottom hinge (9). If necessary
adjust and then tighten the bolts.
Ensure,that the door opens and
closes easily and that there are no
gaps allowing air into the cabinet. If
there are gaps between the door seal
and the cabinet,adjust the door seal
by gently pulling away from the door
using fingers.
11. Fit the other front feet .
12. Fit the plugs on the holes on inner
liner .
13. 19. Carefully stand your appliance.
(You may need somebody to help
you.)
14. Adjust the front feet (See Installation
Instructions)
15. Put back all, loose items and fittings.
16. Wait for at least 4 hours to allow the
system to settle before switching
on.Spare plastic parts supplied with
the appliance are for your future use
during door repositioning.