Filter
Top Products
14
Timer Operation
Your hob has a timer built in which can either be used to automatically switch off
a cooking zone after a pre set period of time, or as an alarm reminder. The timer
features a maximum duration of 99 minutes.
Automatic cook stop 1. Touch pad , on the timer controller, by the
symbol. A ‘t’ will appear in each hotplate control display.
2. Select the hotplate to be timed using the pad, and set to
the desired energy level.
3. Set the timer to the desired duration. Once the time period
has elapsed the element will switch off and an alarm will
sound. The alarm can be stopped by pressing any touch
pad.
4. To cancel a countdown duration, either reduce the time
period to ‘0’ using the pad, or press both and
pads simultaneously.
Alarm 1. Set required energy level for elements required.
2. Touch pad , on the timer controller, indicated by
symbol until the time duration required is reached.
A ‘t’ will appear in each hotplate control display. For Alarm
only, it is not necessary to select a hotplate. After 10
seconds the controller will beep and the displays will revert
to showing energy level.
The alarm will sound once the time has elapsed, and can
be stopped by pressing any of the touch pads.
3. To cancel an alarm duration, either reduce the time period
to ‘0’ using the pad, or press both and pads
simultaneously.
7
Installing your hob
Belling built-under The hob can be fitted above a Belling built-under single or double
single oven unit or oven unit if required.
double oven unit
For your own safety, we recommend that your hob and oven are
connected by a competent electrician. The installation must comply
with current I.E.E. Wiring Regulations.
Follow the installation instructions supplied with the oven unit. To
make sure that there is adequate clearance between the top of the
oven unit and the underside of the hob, the oven support shelf
must be at least 615mm or 705mm from the underside of the
worktop, depending on the type of oven being fitted, shown in the
diagram below. Fit an infill piece along the underside front edge of
the work top to form the top of the oven cavity where required.
Fit the hob before mounting the oven in its cavity, making sure that
the cables are looped well to the back.