Filter
Top Products
Installation Instructions
Installation advice - cabinetry
Dealing with sides, cross-rails and back-panels
in cabinetry
Depending on the cabinets, the worktop thickness and
the hob positioning, it is possible for the hob base
and/or the clamp brackets to interfere with parts of
the cabinet. These can be dealt with as follows:
Cabinet sides
If the hob is to be installed across the top of two cabi-
net housing units, then the base of the hob may inter-
fere with the sides of these units. It will be necessary
to cut away the top of the unit sides locally to clear
the hob and/or the clamp brackets.
Cross-rails
1. Interference with hob base
If there are any cross-rails which obstruct the hob
base by running across the worktop cutout, they
can simply be removed or locally cut-away to allow
the hob to be installed, depending on the particu-
lar installation. Any modifications must ensure
that the strength of the cabinet is maintained.
2. Interference with clamp brackets
If there are any cross-rails which prevent the
clamps from being positioned on the front or rear
edges of the hob, then they can be removed or
locally cut-away around the brackets to allow the
brackets to be installed. Any modifications must
ensure that the strength of the cabinet is main-
tained.
Back-panel
If the cabinet has a back-panel which prevents the
clamps from being positioned on the rear edge of the
hob, then this panel can be completely removed or
locally cut-away to allow the brackets to be installed.
21