Filter
Top Products
Installation Instructions
Installation above an oven
Refer to the manufacturer’s instructions for clearances
above the oven.
We recommend a 9mm gap between the bottom of the
hob and appliance, should the work surface be less than
38mm deep.
In the case of a pyrolytic oven
If installing the hob above a pyrolytic oven, additional
provision for air circulation / ventilation may be required.
Due to the excessive temperatures attained during pyroly-
sis, using the hob at the same time may cause the thermal
safety device within the hob to operate.
Clearances and dimensions - requirements
1. No shelf or overhang of combustible material should
be closer than 650mm above the hob.
2. There must be a minimum clearance of 50mm
between the edges of the hob and any side walls;
this clearance must be maintained up to 420mm
above the worktop.
3. There must be a minimum clearance of 50mm
between the rear edge of the hob and the rear
wall. This clearance must be maintained up to
650mm above the worktop.
4. When installing an extractor hood above the hob,
refer to their Manufacturer’s instructions.
22
50mm
min
9mm
5mm min
air gap
piiP PfPpii
riiP PfPrii
ni
ni
nli
P P
P P
P P
P
poi
P P
P
om P
P
P
ooo
nso
piiPfPom P
riiPfPkim P
420mm
650mm above level
of pan supports
wall unit
wall unit
600 hob - 600mm
This area must
be kept clear of
combustible
materials
40mm
40mm
worktop
53mm min
rear wall
480
mm
550mm
cutout
side wall
53mm min