Filter
Top Products
829A Ow n e r /Op e r a t O r Ma n u a l •
11
829A OWNER/OPERATOR MANUAL • 11
Electrical failure
1. Is slicer fully plugged into a properly grounded 115V AC outlet? If properly connected, the
white power ON light should be illuminated when the slicer is on.
2. Inspect power cord. Has it been damaged, cutting off electrical flow? If so, call your
Berkel serviceman to replace the power cord.
3. Are you getting electricity from the wall outlet? Check by plugging in another piece of equipment
with the same electrical requirements. Also, check circuit breaker or fuse.
4. If you are getting electrical power and your slicer is still not operating, contact your Berkel
serviceman.
Thickness control knob not operating gauge plate
1. If the thickness control knob is not opening and closing the gauge plate properly, it is a sign
that the internal mechanism has suffered some loss of adjustment. Do not try to adjust the
mechanism yourself. Call your Berkel Serviceman.
Not able to remove the product table
1. Is the index knob completely closed and is the table in the home, or most forward position?
If correction of any of the above conditions does not result in a functional slicer, call your
Designated Berkel Service Location.
REPAIR PARTS/REPAIR SERVICE
Please contact your Designated Berkel Service Location for any repair parts and/or repair
service required on your Berkel slicer. Additional information may be obtained from:
Service Support Center
Berkel Company
866/723-7535
www.berkel.com