Filter
Top Products
Continuous Feed Food Processors
Berkel M2000 / M3000
7
INSTALLING & REMOVING SLICERS
& SHREDDERS
OPERATING INSTRUCTIONS
INSTALLING OF SLICERS, JULIENNE SLICERS AND SHREDDERS
Disengage the magnetic toggle lock (A) and open the feed hopper lid until it rests on the back of
the base.
Select the desired SLICER and place it onto the drive shaft until the top of the slicer is flush with
the top end of the drive shaft. Close the feed hopper lid and engage the magnetic toggle switch.
Turn the ON/OFF SWITCH into the ON POSITION and start slicing your vegetables, either using
the small or large feed hopper tube.
REMOVING OF SLICING ACCESSORIES
Turn ON/OFF SWITCH to OFF POSITION (E). Disengage magnetic toggle lock (A) and open feed
hopper lid until it rests on the back of the base.
Hold SLICER with both hands and rotate counter clockwise until the slicer bushing is disengaged
from the drive shaft pin. Lift SLICER off the drive shaft, clean it and place the SLICER back into
the storage rack which is automatically supplied with your new Berkel Food Processor.
Clean your Berkel Food Processor - SEE CLEANING - and close feed hopper lid. Unplug
the power supply cord while the Berkel Food Processor is not in use.