Filter
Top Products
25
SURFACE BURNER OPERATION
THERMOCOUPLE SAFETY VALVE
Each surface burner of a Bertazzoni range is
equipped with a thermocouple safety device.
The thermocouple opens the flow of gas to the
burner only when hot. Should the flame go off,
the thermocouple will immediately close the gas
flow to the burner eliminating any risk to your
home.
For faster activation of the thermocouple, always
light the burners on maximum power. This will
allow the thermocouple to reach the optimum
temperature in the fastest time.
ELECTRIC IGNITION
To activate the electric ignition, simply turn the
control knob counter‐clockwise to maximum
power (
position). Press the knob to start the
flow of gas and the ignition spark. The spark will
released at the metal tip of the white ceramic pin
located on the side of the burner. Once the flame
is on, release the control knob gently.
If the flame turns off, repeat the above
procedure.
The dual power‐burner is composed by two
burners (inside and outside). Each burner is
activated by a separate control knob. The two
burners can be operated separately or together
for maximum power. To activate the power‐
burner, turn on the central burner first, then turn
on the external ring.
ATTENTION: do not ignite burners if the black
burner cap is not installed or not centred. The
flame will be irregular.
MANUAL IGNITION
Manual ignition is always possible even when the
power is cut off or in the event of power failure.
Turn the control knob counter‐clockwise to the
MAXIMUM position. Light the flame with a
kitchen lighter or with a match.
TIPS FOR USING BURNERS CORRECTLY
WARNING!
KEEP CHILDREN AT A SAFE DISTANCE FROM THE
APPLIANCE DURING OPERATION.
DO NOT ALLOW CHILDREN TO OPERATE THE
APPLIANCE.
1. Always check that the burner caps are
properly installed before operation.
2. Verify that the flame of the worktop burners
is completely blue and with regular aspect as
shown below.
3. Always adjust the burner flame so it does not
extend beyond the edge of the pan.