Filter
Top Products
•••• www.beverage-air.com• Pg. 4 ••••
MOVING THE EQUIPMENT
The unit is shipped with casters to facilitate moving the unit into position.
Disconnect the power cord plug from the wall outlet. Remove product, then defrost, and clean the
freezer. Secure all loose items such as baskets and fix the lids by taping them securely in place to
prevent damage. In the moving vehicle, secure the freezer in an upright position and cover it to protect
the outside of the cabinet.
PLACING AND INSTALLING THE EQUIPMENT
THIS UNIT CANNOT BE INSTALLED IN ENVIRONMENTS WITH EXPLOSIVE GASES. THE EQUIPMENT IS
DESIGNED ONLY FOR INDOOR OPERATION.
The unit must be located in an indoor environment.
For the correct performance of the refrigerating system, it is very important to leave at least 10 cm (4")
of free space both at the sides and back to allow proper air circulation. Do not block the grills on the
side or back of the cabinet.
ENERGY SAVINGS IDEAS
The location of the cooler must be kept away from sources of heat and humidity including direct
sunlight, toasters, ovens, coffee warmers, other appliances condenser air discharge, infrared heaters, or
other heat generating appliances.
Overloading the freezer forces the compressor to run longer. Do not exceed the load limit according to
labels fixed on the inner cabinet (which corresponds to the baskets height).
Product to be loaded should be at -4° F (-20° C) since the equipment is intended for maintaining a cool
product at 0° F (-18° C) at load level rather than freezing a warm product
Keep the lids closed to avoid warm air and moisture getting into the freezer.