Filter
Top Products
Attaching the Bare Floor Tool Continued*
Cleaning Bare Floors
*Available with select models only.
Remove Dirty Water Tank.
Remove Brush by depressing tabs on the Cross Action
™
Brush
outward with thumbs until the Brush loosens.
Add Bare Floor Tool underneath the Floor Nozzle by sliding
notches and tabs into the opening until it is secure. Make sure
tabs on the Bare Floor Tool snap over front lip of
Floor Nozzle.
Replace empty Dirty Water Tank.
Empty and rinse Clean Water Tank.
Using the Formula Measuring Cap, add two (2) capfuls of
BISSELL
®
Floor Cleansing Formula
™
to the Clean Water Tank.
Add 1/2-gallon of hot (NOT boiling) tap water. Fill only to fill
line – do not overfill.
Turn Formula Measuring Cap clockwise until secure.
Rotate Quick Release Cord Wrap
™
and plug in.
Turn Power Switch [back of Lower Body] to ( ) ON.
Slowly move QuickSteamer back and forth over soiled surface
one time while depressing Trigger. Do not overwet.
Repeat motion over same area without depressing Trigger.
Repeat Steps 1 and 2 until no more dirt can be removed.
If Floor Nozzle stops spraying, turn Power Switch to
OFF ( ) and check water and cleaning solution levels. Refill
if needed.
WARNING:
The Dirty Water Tank
holds approximately 1/2
gallon of soiled liquid.
Filling past the fill line
can damage unit.
WARNING:
Do not lay QuickSteamer
on its back with Clean
Water Tank in place. Do
not tip up foot with Dirty
Water Tank in place.
1.
2.
4.
3.
1.
2.
4.
3.
5.
6.
7.
8.
9.
Bare Floor Tool
Cross Action
™
Brush
Tabs
Floor
nozzle
front lip