Black & Decker FX1200 Food Processor User Manual


 
-3-
English
Intended use
Your Black & Decker Food Processor has been
designed for processing ingredients as listed in this
manual.
This appliance is intended for indoor consumer use
only.
Safety Instructions
Warning! When using mains-powered appliances,
basic safety precautions, including the following,
should always be followed to reduce the risk of
fire, electric shock, personal injury and material
damage.
Read all of this manual carefully before using the
appliance.
The intended use is described in this manual. The
use of any accessory or attachment or the
performance of any operation with this appliance
other than those recommended in this instruction
manual may present a risk of personal injury.
Retain this manual for future reference.
Always route the cord carefully to avoid a tripping
hazard.
Never operate an appliance directly below the
socket-outlet it is connected to.
Using your appliance
Make sure that the appliance is switched off
before connecting to or disconnecting from the
power supply.
Always take care when using the appliance.
Do not use the appliance outdoors.
Never pull the power supply cord to disconnect
the plug from the socket. Keep the power supply
cord away from heat, oil and sharp edges.
Disconnect the appliance from the power supply
when not in use, before fitting or removing parts,
maintenance and before cleaning.
Surfaces may be hot during use and during the
cool down period
Do not operate or place any part of this appliance
on or near any hot surface, such as a gas or
electric burner or in a heated oven.
When using an extension cord with your
appliance, make sure the extension cord is
correctly wired & rated for its use.
Safety of others
Do not allow children or any person unfamiliar
with these instructions to use the appliance.
Do not allow children or animals to come near
the work area or to touch the appliance or power
supply cord. Close supervision is necessary
when the appliance is used near children.
Never leave an appliance unattended when in
use
Do not allow the cord set to hang over bench
tops
After use
Switch off and remove the plug from the socket
before leaving the appliance unattended and
before changing, cleaning or inspecting any parts
of the appliance.
When not in use, the appliance should be stored
in a dry place. Children should not have access
to stored appliances.
Inspection and repairs
Before use, check the appliance for damaged or
defective parts. Check for breakage of parts,
damage to switches and any other conditions
that may affect its operation.
Do not use the appliance if any part is damaged
or defective.
Have any damaged or defective parts repaired or
replaced by an authorised repair agent.
Before use, check the power supply cord for
signs of damage, ageing and wear.
Do not use the appliance if the power supply cord
or mains plug is damaged or defective.
If the power supply cord or mains plug is
damaged or defective it must be repaired by the
manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard. Do
not cut the power supply cord and do not
attempt to repair it yourself.
Never attempt to remove or replace any parts
other than those specified in this manual.
• Do not attempt to repair the appliance. Take it to
your nearest Black & Decker-owned or
authorised Service Centre for repair.
Double insulation
This appliance is double insulated; therefore
no earth wire is required. Always check that
the power supply corresponds to the voltage
on the rating plate.
Additional safety instructions for Food
Processors
Do not immerse the appliance, cord set or plug in
liquids
Always leave sufficient space around the
appliance for ventilation
Keep loose clothing, hair, jewellery, etc. away
from moving parts.
Do not use the unit if you have wet hands or bare
feet.
Care is needed when handling cutting blades,
especially when removing the blades from the
bowl, emptying the bowl and during cleaning.
“Switch off the appliance before changing
accessories or approaching parts which move in
use”.