Filter
Top Products
3
1) BURNERS
A diagram is screen-printed above each knob on the
front panel. This diagram indicates to which burner
the knob in question corresponds. After having
opened the gas mains or gas bottle tap, light the
burners as described below:
- Manual ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
place a lighted match near the burner.
- Electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress and release the ignition button.
- Automatic electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress the knob.
- Lighting burners equipped with flame failure
device
The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the full on position (large flame
fig. 1) and come to a stop. Now depress the knob in
question and repeat the previously indicated
operations.
Keep the knob depressed for about 10 seconds
once the burner has ignited.
Note: you are advised not to try and light a burner if
the flame divider (Burner Cap) is not correctly placed.
In the event of burner flames being accidentally
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least 1 minute.
HOW TO USE THE BURNERS
In order to achieve maximum efficiency with the least
possible gas consumption:
- Use adequate pans for each burner (consult the
following table and fig. 2).
- When the pan comes to the boil, set the knob to the
reduced rate position (small flame fig. 1).
- Always place a lid on the pans.
Burners Power ratings Pan Ø in cm
Natural U-LPG
Ultra rapid 11.9 MJ 11.9 MJ 22 ÷ 28
Semirapid 6.3 MJ 6.3 MJ 16 ÷ 18
Auxiliary 3.6 MJ 3.6 MJ 10 ÷ 14
WARNINGS:
- Burners with flame failure device may only be
ignited when the relative knob has been set to
the Full on position (large flame fig. 1).
- Matches can be used to ignite the burners in a
blackout.
- Never leave the appliance unattended when the
burners are being used. Make sure there are no
children in the near vicinity. Particularly make
sure that the pan handles are correctly
positioned and keep a check on foods requiring
oil and grease to cook since these products can
easily catch fire.
- Do not spray aerosols in the vicinity of this
appliance while it is in operation.
- This appliance is not to be installed in marine
craft. Where this appliance is installed in a
caravan, it shall not be used as a space heater.
- Do not store or use flammable liquids or items in
the vicinity of the hotplate.
USE
FIG. 1 FIG. 2