Filter
Top Products
9
COOKER SECTION
CAUTION: Live steam and accumulated hot water in the compartment may
be released when the door is opened.
Start-up procedures for your steamer must be completed once daily prior to operation
(see instruction plate or above for boiler start up procedures). With ready pilot light on,
preheat steamer compartment for one minute when the steamer is to be first used for the
day or whenever the compartment is cold.
1. Close compartment doors and set timer to “1 minute”.
2. When buzzer sounds, set timer to the “OFF” position.
3. Steamer is now ready for cooking.
4. With cooking compartment preheated and ready pilot light on, place pans of food to
be cooked into compartment and shut door.
5. Set timer to cooking time desired. Cooking cycle may be interrupted at any time by
opening door and resumed again by closing door.
6. When buzzer sounds, it indicates the end of the cooking cycle and that no more
steam is entering the compartment. Cooking pilot light will go off and ready pilot light
will come on. Buzzer must be shut off by turning the timer to its off position.
CAUTION: An obstructed drain can cause personal injury or property
damage.
Frequently check that the compartment drain and plumbing is free of all obstructions.
Never place food containers, food or food portion bags in the cooking compartment in
such a way that the compartment drain becomes obstructed.
SHUT DOWN
1. To shut down cooking compartment, set timers to their OFF position and leave doors
slightly open.
2. At the end of the day, the steam supply must be shut off. Open the door of cabinet
base and turn off power switch. Open manual drain valve. If unit is equipped with
automatic blowdown valve, it will open and drain the boiler.
If unit is equipped with CSD-1 controls also refer to separate manual supplied with unit.
Each compartment is equipped with a removable drain screen. Frequently check the drain
screen for accumulation of food particles. Should food particles accumulate against, or clog
the drain screen, remove it, clean it thoroughly and then replace it in its original position.