Bloomfield 1088 Coffeemaker User Manual


 
8
OPERATION (continued)
ELECTRONIC FEATURES
Energizing the Brewer
When electric power is applied to the unit, all the lights will flash four
times and four beeps will sound. The unit will be
OFF.
Press the ON/OFF key. Four beeps will sound and all lights will flash
once. The POWER indicator will remain
ON. If the water temperature
is more than 10ºF below the setpoint, the HEAT indicator will glow until
water temperature reaches setpoint.
Press the ON/OFF key again to turn the brewer
OFF. Three beeps will
sound, the tank heater and all warmers will be switched off, and all
indicator lights will go out.
Brew Settings
See pages 15 & 16 for setting Brew Time and Temperature.
ABS™ (Automatic Brew Start)
Start a brew by pressing BREW. A single beep will sound. The system
will verify that the water in the tank is at the proper temperature. If it is,
brew will start immediately. Otherwise, the BREW indicator will flash
(Brew Waiting Mode) until the water reaches setpoint temperature,
then the indicator will glow and brew will commence. If the main
warmer is off, it will be energized automatically.
At the conclusion of the brew cycle, three beeps will sound.
NOTE: To override Brew Waiting Mode, press and hold the BREW
key for 3 seconds while the BREW indicator is flashing. Brew will
begin regardless of water temperature. To avoid under-temperature
brews, this feature should only be used when setting brew volumes.
NOTE: Brew Waiting Mode (BREW indicator flashing) prevents
multiple, unattended brews. While the BREW indicator is on or
flashing, any additional strokes of the BREW key will be ignored (there
will be a beep each time the key is pressed, however). Another brew
cannot be initiated until the previous brew is complete.
The Brew Waiting Time, also called Dripout Time, (interval between
when the brew is initiated and the audible signal sounds at the end
of the brew) may be adjusted between 2 and 8 minutes at the Brew
Signal Timer dial on the controller. See page 16.
Brew Cancel
To cancel a brew in progress or a brew in waiting, press the CANCEL
key. Two beeps will sound and the BREW indicator will go out.
NOTE: If a brew in progress is cancelled, coffee will continue to flow
until all water delivered has dripped through the brew chamber.
IMPORTANT:
DO NOT energize this
brewer until the water tank
has been filled. Dry firing
will damage heating
elements. See page 6.
Fig. 7 Turning Brewer
ON or OFF
Fig. 8 Initiate a Brew
Fig 9 Brew Cancel
642 75872 Owners Manual E.B.C. Airpot /Thermal