Filter
Top Products
H
41
Base Components – Front Accessible
Fig. 10-9 Fig. 10-10
Fig. 10-11 Fig. 10-12
Fig. 10-13
1
2
Cut Away View
3
1
2
A
B
To remove the Drain Motor, item 1, first remove the
Sump Fill Hose, item 2, by pulling it out from the
Sump and side inlet connections (see Fig. 10-10)
This cut away view shows:
Item 1, Drain Motor.
Item 2, Drain Motor Locking Tab.
Item 3, the Sump Fill Hose and its two
connection points A and B.
Next, remove the wiring
connectors and then while
pulling back on the Locking Tab,
turn the Drain Motor clockwise.
Continue turning the Drain Motor
clockwise until it reaches the two
O’clock stop position. Then
bring the motor out from the
Sump.
The Drain Motor is mounted to
the Sump using a slot and tab fit.
To install the Drain Motor, insert it
back into the Sump at the two
O’clock position making sure that
all three slots and tabs line up,
then turn counter-clockwise until
secure and the Locking Tab locks.