Filter
Top Products
en
16
Note
Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.
Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.
Note
Even if the rinse aid and/or salt refill
indicator is lit, the rinse programme runs
correctly when 3in1 products are used.
If the rinse aid refill indicator
6 or salt
refill
5 indicator is defective and you
would like to switch it off, proceed as
follows:
Switching the rinse aid refill
indicator off and on
Hold down the programme button 3
and press the main switch 1 until the
digital display lights up, then release the
buttons. 4 is indicated on the digital
display
.
Each time the button 3 is pressed,
the set value increases by one; when
the value
is reached, the display
jumps back to
. To switch off,
select the
position.
Switch off the main switch 1 ;
the setting is saved.
Switching the salt refill
indicator / water softening
system off and on
Hold down the programme button B
and switch on the main switch 1 ,
then release the buttons.
The illuminated button
B and the
factory-set value
on the digital
display flash.
To change the setting: press the
programme button B .
Each time the button is pressed, the set
value increases by one; when the value
is reached, the display jumps back
to
(the salt refill indicator / water
softening system has been switched
off).
Switch off the main switch 1 .
The set value is stored within the
device.
Approx. 4 litres of water are required to
regenerate the water softening system.
As a result, the water consumption per
rinse cycle increases by 0 to maximum
4 litres depending on the water hardness
setting.
Note
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
hardness.