Filter
Top Products
en
8
Adding rinse aid
Rinse aid is used in the rinsing cycle to
ensure clear glasses and stain-free
utensils.
Open the lid of the rinse-aid dispenser
29 by pressing the button on the
rinse-aid lid and lifting up the lid.
Pour the rinse-aid into the filler hole
until the level indicator turns dark.
Close the lid, ensuring that you hear it
snap closed.
rinse–aid control
Note
Use only rinse aid for domestic
dishwashers. Spilt rinse aid
may result in excessive foam
formation in the next rinse
cycle. Therefore, remove any
spilt rinse aid with a cloth.
Convenient rinse-aid filling
procedure with half-open door
Open the rinse-aid lid and pull out the
hinged filling aid until it locks into
position.
Slowly fill with rinse aid but do not
overfill.
Close the rinse-aid lid until it clicks shut.
Set Amount of Rinse Aid
The amount of rinse aid is set at the
factory to 4.
Only change this setting if streaks b or
water stains y remain on the dishes.
Hold the Programme button 3 and
press the main switch
1 .
Release both buttons.
In order to change the setting, press the
Programme button
3 .
Each time you press the button the
value increases by one step; once
a value of
is reached the indicator
jumps back to
(Off: The rinse aid
fill indicator 6 does not show a need
to refill).
Switch off the main switch 1 . The set
value is stored within the device.
Note
Only switch off the rinse
aid indicator if you are
using cleaning products
with integrated rinse aid!