Bosch Appliances HBA36B6.0W Oven User Manual


 
14
2. Turn the rotary selector to select the required basic setting
3. Press the X button.
4. Change the basic setting by turning the rotary selector.
5. You can now change other basic settings, as described in
points 2 to 4.
6. Press and hold the ° button until the clock appears. This
takes about four seconds. All changes are saved.
Cancelling
Press the
% button. The changes are not applied.
Automatic switch-off
Your oven has an automatic switch-off function. It is activated if
no cooking time is set and the settings have not been changed
for a long time. The point at which this occurs depends on the
temperature or grill setting that has been set.
Switch-off activated
”‰ appears in the display. Operation is interrupted.
Press any button to make the display message go out. You can
make new settings.
Note: If a cooking time is set, the oven stops heating once the
cooking time has elapsed. The automatic switch-off function is
not necessary.
Cleaning system
The cleaning system regenerates the self-cleaning surfaces in
the cooking compartment.
The self-cleaning surfaces are coated with a highly porous
ceramic layer. This coating absorbs and disintegrates splashes
from baking and roasting while the oven is in operation. If the
surfaces no longer clean sufficiently and dark stains appear,
they can be regenerated with the cleaning system.
Retrofitting the self-cleaning ceiling and side walls
The back wall in the cooking compartment is coated with
ceramic. In order for you to be able to use the cleaning system,
the ceiling and side walls must also be coated. You can obtain
the self-cleaning ceiling and side walls as a special accessory
from the after-sales service.
Changing the basic settings
When you have retrofitted the self-cleaning ceiling and side
walls, you must activate the cleaning system in the basic
settings. To find out how to do this, refer to the Basic settings
section.
Cleaning levels
You can choose from three cleaning levels.
Before cleaning
Remove accessories and cookware from the cooking
compartment.
Cleaning the cooking compartment floor
Before you set the cleaning system, clean the surfaces in the
cooking compartment that are not self-cleaning. Otherwise,
stains will develop that it is not possible to remove.
Use a dish cloth and hot soapy water or a vinegar solution. If
there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.
Setting the cleaning level
1. Press the p button.
Cleaning level 3 is suggested. You can start the cleaning
process immediately with the
n button.
If you wish to change the cleaning level:
2. Select the desired cleaning level using the rotary selector.
3. Press the n button to start the cleaning operation.
The time counts down.
Once cleaning has finished
The oven stops heating.
‹‹:‹‹ appears in the display.
Cancelling the setting
Press and hold the
n button until < 3D hot air, 160 °C
appears. You can make new settings.
Adjusting the cleaning level
Once cleaning starts, the cleaning level can no longer be
changed.
Setting cleaning to run overnight
So that you can use your oven throughout the day, delay the
end of the cleaning process to during the night. See the Time-
setting options section, setting a later end time.
After cleaning
When the cooking compartment has cooled down completely,
wipe the salt residues off the self-cleaning surfaces with a
damp cloth.
Level Degree of cleaning Duration
1 gentle approx. 45 minutes
2moderate approx. 1 hour
3 intensive approx. 1 hour, 15 minutes