Filter
Top Products
English 37
To replace the oven door:
Warming Drawer Maintenance
Removing the Drawer
1. Pull drawer to fully open position.
2. Press down right drawer clip.
3. Lift up left drawer clip.
4. Firmly pull the drawer straight out. Retract cabinet rails
while drawer is removed.
Replacing the Drawer
1. Be sure cabinet rails are pushed inside cabinet.
2. Align the drawer rails with the cabinet rails.
3. Firmly push the drawer straight into the cabinet until
drawer clicks into place.
4. Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rail clips are
properly positioned.
1. Holding the door firmly
in both hands, place
hinges in hinge slots.
2. Catch the small slot at
the base of the hinge
(A) in the bottom of the
hinge slot (B) in the
oven body. Then tilt
the door inward and
slide the hinges into
place. The door
should catch at this
point and remain firmly
attached to the oven
body.
3. Open the door all the
way to expose the
hinges and slots.
4. Push both hinge
levers down and away
from you until flush
with the face of the
oven body.
5. Close and open door
slowly to be sure it is
correctly and securely
in place. Door must be
straight, not crooked.
9 CAUTION
To prevent burns, do not remove drawer while hot.
Be sure drawer is empty before removing.
Low
High
_
Med
Proof
+
On/O
ff
B
LOW
HIGH
_
MED
P
R
O
O
F
+
ON/OFF