Filter
Top Products
9
7. Disassemble the cover:
Take the funnel out of the filler tube in the lid and
remove the lower part of the lid.
8. Clean the blender jug, individual parts of the lid as
well as the blender motor base in the dishwasher
or with normal household detergent.
9. Clean the blade compartment and sealing ring
with a brush under running water only. Detergent
will impair the bearing lubrication.
10. ReĆassemble in reverse sequence.
Troubleshooting
d Risk of electric shock!
Before rectifying a fault, pull out the plug.
Fault Remedial action
Blender does not start Correctly attach the blender and rotate fully into position.
Blade is blocked. Switch off the appliance, empty out the contents
and refill. Switch on the appliance again.
The blender switches off during
operation
Rotate the blender fully into position.
d If any other faults occur, contact Customer
service.