Filter
Top Products
8
1. Place power unit on suitable work
surface.
Before using the machine with any of
the attachments, the power unit should
be placed on a suitable work surface.
The surface should be sturdy, smooth
and clean; make sure that there is no
flour or oil on the surface. A clean,
smooth surface will provide the best
footing for the suction cup feet on
the power unit and will limit slipping
and/or “walking.”
2. Plug power unit into power supply.
Unwind the power unit’s cord to
appropriate length and plug it into
a convenient nearby receptacle.
3. Remove motor drive cover.
If necessary, remove motor drive cover
from drive that will be used and place
it on drive that will not be used. The
cover, when placed on the high-speed
drive, can be locked in position by
pressing down and turning
counterclockwise, see figure 2c.
4. Select attachment to be used.
Select the attachment you wish to use
and place on power unit. See specific
instructions for attachment selected.
Specific instructions are located on
pages listed below:
Attachment Pages
Mixing bowl w/dough hook........ 9–11
Mixing bowl w/twin whisks ....... 11–14
Blender ..................................... 14–17
Slicer/shredder......................... 17–21
Stainless steel bowl................. 22–23
Table 1.
5. Operate unit with rotary switch.
Once the attachment is in place, the
speed of its moving components can
be controlled through the use of the
rotary switch at the front of the power
unit. See figure 2a. The rotary switch
has five positions:
a. “M,” a momentary “pulse” position
that provides full speed and power
for the time it is held in position.
b. “O/Off,” the off position.
c. Four speeds labeled 1, 2 and 3.
Speed 1 is the lowest speed. The
speed increases with each
succeeding step up to the highest
speed, speed 3.
All models of the Bosch Universal
Series Kitchen Machines incorporate
a built-in safety cutout switch to
protect the motor against overheating.
If the safety becomes activated, the
power unit will stop. If power unit
should stop even though there is power
to the unit see TROUBLESHOOTING
at the back of this manual .
6. Turn power unit off.
When your work with the attachment
is completed or the capacity of the
batch-feed attachment has been
reached, turn the power unit to the Off
position, “O/Off,” and unplug.
7. Remove the attachment.
Remove the attachment from the
power unit, per instructions for the
specific attachment being used.
8. Continue use.
If the attachment was of the batch-feed
type and you wish to continue using
the attachment, empty the bowl or jar
of the attachment per its specific
instructions and reinstall the
attachment as before. Repeat steps
5 through 7 as often as necessary to
complete work.