Filter
Top Products
14
Care and Maintenance (continued)
To reinstall the top spray arm:
1. Return the top spray arm to its installed
position.
2. Return the locking nut to its installed
position and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller
guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the
dishwasher tub.
2. Grasp and lift the bottom spray arm as
shown in Figure 20.
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed
position and press it so that it snaps into
place.
2. Return the bottom rack to its installed
position.
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, flush
them under running water.
Check/Clean the Filter System
The filter system is located on the inside of your
dishwasher under the lower rack and is easily
accessible.
During normal use, the filter system is
self-cleaning. You should occasionally inspect it
for foreign objects and clean it when necessary.
To Remove the Filter Assembly:
1. Remove the bottom rack.
2. Remove the assembly as shown in Figure
21.
Figure 21
3. Carefully examine the assembly. If you find
debris, turn it upside-down and gently tap it
on a surface such as a countertop to
dislodge and remove the debris. Flush the
filter clean by holding it under running water.
4. To reinstall, place the filter assembly back in
the unit and turn the center in a clockwise
direction to lock in place.
Figure 20
To avoid injury, do not reach into the large
object trap with your fingers. The large
object trap could contain sharp objects.
CAUTION
Filter Assembly