Filter
Top Products
10
CLEANING AND MAINTENANCE
Drain Plug
Cleaning
The outer casing of your water filter chiller
can be cleaned using a soft damp cloth
and a non-abrasive cleaner.
It is important that the inside of the chiller
is cleaned regularly. We recommend
that this is done at least monthly e.g.
when changing the Maxtra cartridge. Also,
ensure that the dispensing nozzle is
cleaned regularly.
Cleaning Instructions
1. Disconnect the chiller from the
electrical socket and drain all the
water by unscrewing the drain plug
on the bottom of the unit over a sink
or large container.
2. When empty of water replace the
drain plug.
3. Remove the lid and top up the water
tank, leaving the bottom water tank
in place.
4. Pour approximately 2 litres of water
into the bottom tank, and add a non-
tainting sterilising fluid such as Milton
(following manufacturer’s guidelines
for dilution).
5. Depress dispensing lever until fluid
starts to come out of the dispensing
nozzle.
6. Stop depressing the lever when the
fluid comes through the nozzle.
7. Leave the fluid to stand in the chiller
as recommended by the fluid
manufacturers instructions (normally
approximately 10/15 minutes).
8. Drain the chiller using the drain plug
at the bottom of the unit over a sink or
large container. Replace the drain
plug.
9. To flush through the system pour
approximately 2 litres of water into
the tank, depress the dispensing
lever until water starts to come out of
the dispensing nozzle, and then
empty using the drain plug at the
bottom of the unit over a sink or large
container. Replace the drain plug.
10. Your chiller is now ready to use. Fill
the chiller tanks with tap water as per
chiller instructions, plug the unit into
the socket and turn on. Use the chiller
as normal.
Storage
If you are not going to use your water filter
chiller for an extended time disconnect
the unit from the mains and drain the
water using the drain plug at the bottom
of the unit over a sink or large container.
Remove the filter cartridge and discard.
Leave the lid off and allow the unit to dry
thoroughly.
If the chiller has not been used for an
extended time, follow the internal
cleaning instructions above before
reusing.