7
USING YOUR WATER FILTER/CHILLER
For optimum enjoyment, we recommend
that if your water chiller has not been
used for 1 day or more, you first draw half
a glass of water and dispose of it. It is
possible to use the unit without power
but the water will not be chilled.
Remember that water is a foodstuff.
Please consume filtered water within 2
days.
To empty filtered water from the system,
use the plug in the base of the chiller as
instructed in the storage section on page
10.
When replacing the bottom 2 litre filtered
water tank, please ensure that there is
no water in the inner well (illustrated
below).
✎✎
✎✎
✎ NOTE
There is a risk of leakage from the
split joint between the top tank and
filtered water tank. This may occur if
the unit is moved or disturbed when
both tanks are at maximum capacity.
To avoid leakage, draw off water using
the lever to empty the top tank so that
it does not overflow when moved.
If there is water present, dispense the
water using the lever until the well is
empty.
Should water spill from the tank it is not
dangerous. Do not grasp or pull on the
tank sections to move or reposition the
unit.
Inner well
Troubleshooting
Water is not dispensed:
• Make sure that there is water in the
tank.
• Air trapped in the filter cartridge may
stop water flowing into the filtered
water tank. The cartridge must be
immersed in cold water and agitated
to removed any air bubbles before
installation.
• Filter is blocked. Replace.
• Air can become trapped in the
internal tank. Press the dispensing
lever until clear water dispenses
without any air bubbles. This may
take some time.
Chiller light tuning off and on:
• The chiller light will not stay on
permanently. It will cycle on and off
as the temperature of the water is
maintained.