Filter
Top Products
16
PAge heAder
OPERATING YOUR BREVILLE PRODUCT
• In a microwave the heat is produced
INSIDE the food. In all other conventional
cooking methods, heat is applied from
OUTSIDE through transference of heat
by convection or radiation.
• Microwave energy penetrates the food
to a depth of about 25mm. Small foods
under 5cm in diameter such as eggs are
penetrated to the centre from all sides.
In larger foods, energy creates heat in
the outer layer; this then moves to the
centre by conduction, as it does with
conventional cooking.
SETTING THE CLOCK
When power is activated, the LED will
display 0:00. The input time should be
within 0:00–23:59.
Example: To set 12:12.
1. Press the SET CLOCK button, the hour
figures will flash, and the indicator for
clock will light.
2. Press the number buttons of 1, 2, 1, 2
in order.
3. Press SET CLOCK to finish clock
setting. The indicator for clock will
go out, ‘:’ will flash, and the time will
illuminate.
NOTE
In the process of clock setting, if
STOP/CLEAR is pressed or if there
is no operation within 1 minute, the
oven will go back to the previous
status automatically.
MICROWAVE COOKING
1. Using the number pad, input the
cooking time; maximum cooking time
is 99 minutes and 99 seconds.
2. Press “START / +30 SEC” button to
commence operation.
NOTE
Number “0” cannot be input first so
when the “0” is pressed before any
other numbers, “WEIGHT DEFROST”
function will be initiated.
NOTE
This mode will have microwave oven
working at 100% power level.
MICROWAVE COOKING WITH
POWER LEVELS
Select different microwave power levels and
set cooking time as desired.
Option 1
1. Using the number pad, input the
cooking time; maximum cooking time is
99 minutes and 99 seconds.
2. Press the POWER LEVEL (continue
to press) until desired power level is
selected.
3. Press “START / +30 SEC” button to
commence operation.
Example: Microwave oven cooking with 50%
power for 15 minutes:
i. Press 1, 5, 0, 0 respectively.
ii. Press the POWER LEVEL button once:
100%
iii. Press the POWER LEVEL button twice:
80%
iv. Press the POWER LEVEL button three
times: 50%
v. Press “START / +30 SEC” button to
commence operation.