Breville BWC200 Water Dispenser User Manual


 
9
OPERATING YOUR BREVILLE CHILL CONTROL™
OPERATING
your Breville Chill Control™
BEFORE FIRST USE
Before first use, remove and safely discard
all promotional labels and packing materials
attached to the Breville Chill Control™.
Remove the filter cartridge from the plastic
packaging and keep in a safe place. Do not
re-insert the filter until (a) flushing process
and (b) preparation of filter cartridge has
been completed (refer to page 10).
Remove the lid, plastic plug and pre-filter
tank and wash in warm soapy water. Rinse
and wipe dry using new cloth. Wipe exterior
of appliance with a soft damp cloth and
dry thoroughly.
Place the appliance on a dry, flat level
surface. Plug into 230-240V outlet and
turn power On.
NOTE
Do not place the appliance directly
against the wall. Ensure there is
adequate airflow both at the rear and
sides by positioning the appliance
10cm away from the wall.
FLUSHING THE BREVILLE
CHILL CONTROL
It is important that you flush and rinse out
the dispensing system before using the
appliance for the first time.
Please note you should carry out these steps
without the BRITA
MAXTRA cartridge in
place. Plug the appliance into an appropriate
electrical outlet and switch On.
1. Remove filter cartridge from the
pre-filter tank and the removable plug
from filter tank.
2. Fill the pre-filter tank to the maximum
level with water.
3. Position the variable temperature slider
to the centre.
4. Place a large container or jug under
the spout.
5. Press the dispenser lever until water
reaches the MIN level, then discard
remaining water.
6. Repeat this process with cold tap water
twice and discard.
7. Do not fill above the maximum level
indicated.
NOTE
If the plastic plug is inserted while
the cooling tank is empty, it will take
approximately 7 minutes for the air to
release from the cooling tank.
During this time chilled water cannot
be dispensed.
THE BRITA
MAXTRA CARBON
FILTRATION PROCESS
Activated carbon reduces chlorine, metals
such as lead, copper and limescale for
cleaner, clearer better tasting water.
Leaves in flouride.
PREPARING THE BRITA
MAXTRA
FILTER CARTRIDGE
1. Remove the filter cartridge from its
wrapping.
NOTE
It is normal for the cartridge to
appear moist when removed from its
wrapping, this is simply condensation.