Filter
Top Products
11
Brewing Coffee
1. Make sure the Selector Control is in the
‘STAND BY’ position.
2. Plug the power cord into a 120V
electrical outlet. Set the power switch
to the ‘ON’ position.
3. As soon as the orange ‘HEATING’ light
turns off, the machine is heated up.
4. Make sure the drip tray is in place.
5. Place one or two pre-heated cups
beneath the filter holder. When brewing
into two cups at the same time, no
more than 1oz should be extracted into
either cup.
6. Set the selector control to the
‘ESPRESSO’ position.
7. After a few seconds, aromatic coffee
will begin to run through.
8. When sufficient coffee has flowed into
the cups, set the selector control to the
‘STAND BY’ position. This will stop the
flow of coffee.
9. If you do not need to use the steam
function, set the power switch to the
‘STAND BY’ position, unplug the power
cord and allow the machine to cool.
10. Remove the filter holder from the brew
head and turn the filter holder upside
down to empty the used coffee (used
coffee grounds should be thrown away
with domestic waste and not down the
sink which may block drains). Rinse
the filter and filter holder with water and
allow to dry.
NOTE:
The machine remains ready for brewing
and maintains a constant heating
temperature as long as the Power
switch is left in the ‘On’ position. If the
temperature should drop, the orange
control light will illuminate and the heater
will automatically heat up to the correct
brewing temperature.
OPERATING YOUR BREVILLE CAFÉ MODENA ESPRESSO MACHINE
Preparing Espresso Pods
Your Café Modena can be used with
most leading brands of espresso pods. To
prepare the pod for brewing, place the pod
in the pod filter and ensure that all of the
pod’s surface area is fitted inside the filter. If
the edges of the pod overflow the filter, you
will need to trim them off until the pod is
contained wholly within the filter. Lock the
filter holder in place and brew the coffee as
per the instructions on page 10.
NOTE:
The quality of the coffee and créma
produced will be dependent on the type
of pod used. Only use the pod filter when
using the espresso pods.
How to Froth Milk for a Cappuccino
or Latte
The Breville Café Modena comes complete
with steam wand and frothing attachment.
If less froth is required, remove the Frothing
Attachment and steam the milk using the
Steam Wand. To remove the Frothing
Attachment, ensure it is cool, then simply
pull down and remove.
To refit the Frothing Attachment ensure it
is securely attached to the Steam Wand
by inserting it onto the Steam Wand and
pushing firmly upwards.
The first step in making a cappuccino
or latté is to make a short espresso (see
"Brewing Coffee"), then:
1. Fill the stainless steel frothing jug 1⁄3 full
with cold milk.
2. When the orange 'HEATING' light has
turned off, quickly insert the steam
wand into the jug of the milk so that the
Frothing Attachement is just immersed
into the milk.
3. Set the Selector Control to the
‘STEAM’ position.