Filter
Top Products
15
Cleaning the Housing /
Cup Warming Tray
1. The outer housing can be cleaned with
a soft, damp cloth (do not use abrasive
agents or cloths which can scratch
the surfaces).
Cleaning the Filters, Filter Holder and
Brewing Head
1. Directly after use, remove used coffee
grounds and rinse the stainless steel
filters and filter holder under running
water. Then place the empty filter and
filter holder back onto the machine
and brew water through it for 10-15
seconds. Should the fine holes in the
filters become blocked, then a normal
dishwashing brush should be used (do
not use a brush with metal bristles).
2. The brewing head should be wiped
with a damp cloth to remove any old
espresso grounds.
3. It is advisable to periodically run water
through the unit with the filter in place
but without any coffee to clean out any
old coffee grounds.
Cleaning the Drip Tray
1. The drip tray should be removed,
emptied and cleaned at regular intervals,
particularly when the water level indicator
is exposed, indicating the drip tray is full.
2. Remove the grid, steam baffle and
water level indicator from the drip tray;
wash all 4 parts with water and non-
abrasive washing liquid before
rinsing and drying.
NOTE:
Do not place any of the components in
the dishwasher.
DO NOT IMMERSE ANY PART
OF YOUR BREVILLE ESPRESSO
MACHINE IN WATER OR ANY OTHER
LIQUID.
CARE AND CLEANING
Before cleaning, ensure the Selector Control
is in the ‘STAND BY’ position. Unplug the
appliance from the power outlet and allow
the unit to cool.
Cleaning the Steam Wand
and Froth Enhancer
1. The Steam Wand and Froth Enhancer
should always be cleaned after
frothing milk.
2. Remove the Froth Enhancer and rinse
under warm tap water.
3. Wipe the Steam Wand with a damp cloth.
4. Briefly set the Selector Control to the
‘STEAM’ position to clear any remaining
milk from the steam wand.
5. If the Steam Wand becomes blocked,
wait for the machine to cool before using
the pin on the Cleaning Tool to clear the
opening. (see illustration below)
6. If the Steam Wand continues to be
blocked, the tip of the Steam Wand
can be removed by using the spanner
in the middle of the Cleaning Tool. (see
illustration below)
7. Soak the tip in hot water before using
the pin on the Cleaning Tool to unblock.
Replace the tip back onto the Steam
Wand and secure with the Cleaning Tool.
!