Filter
Top Products
7
OPERATING YOUR BREVILLE VEGETABLE AND
CITRUS DUO
Step 1. Wash your selected fruit and
vegetables and cut to size in order to fit
through the feed chute before turning juicer
on.
Step 2. Ensure the Vegetable and Citrus
Duo is correctly assembled (See page 5)
and that the safety locking arms are locked
into position.
Ensure the juice jug is placed underneath
the juice outlet.
Step 3. Plug the power cord into a
230/240v power outlet and turn the power
on. Switch the ‘On/Off’ switch on the
Vegetable and Citrus Duo to the ON position
to start juicer operating.
Step 4. With the motor running, then place
the pre-cut food down the feed chute. Using
the food pusher, gently guide the food down
the chute.
NEVER USE FINGERS TO
PUSH FOOD DOWN THE FEED
CHUTE OR TO CLEAR THE
CHUTE WHILE THE JUICER IS
OPERATING. ALWAYS USE
THE FOOD PUSHER
PROVIDED.
Step 5. Juice will flow into the juice jug and
the separated pulp will accumulate in the
pulp container.
Step 6. When juicing is complete, turn the
‘ON/OFF’ switch to the OFF position, switch
off the power at the power outlet and
remove the plug.
ALWAYS turn the Vegetable and Citrus Duo
OFF and remove the plug from the power
outlet before unlocking and opening the unit.
ALWAYS ensure that the motor has come
to a complete standstill before unlatching
and lifting the lid to remove the pulp
container.
Operating the Vegetable
Juice Extractor
To extract the maximum
amount of juice always
push the food pusher down
slowly.
☛
NOTE!
When juicing carrots place
the tip of the carrot in last.
☛
NOTE!
Figure 1
6
ASSEMBLING YOUR BREVILLE VEGETABLE
AND CITRUS DUO (CONTINUED)
Step 1. Place motor base and pulp
container
Place the motor base on a dry, level surface.
Place the pulp container on top of the drive
shaft.
Step 2. Place juicer cone into position
Sit the plastic juicer cone onto the pulp
container, over the drive shaft coupling.
Step 3. Lock the juicer rim into place
Place the juicer rim onto the top of the pulp
containers and secure it by raising and
clicking the two safety locking arms on the
sides of the juicer into ‘lock’ position. If the
safety locking arms are not locked into
position, a built-in safety device will prevent
the Vegetable and Citrus Duo from
operating.
Step 4. Position the juice jug
Place the juice jug directly underneath the
juice outlet on the right hand side of the
motor base.
Assembling as a Citrus
Juice Extractor
Figure 1
Figure 2
Figure 1
Do not allow the pulp
container to overfill as this
may prevent correct
operation or damage the
unit.
☛
NOTE!
➞
➞
Lock
Drive
shaft
coupling