Filter
Top Products
- 9 -
12. INSTALL THE BLOWER (INTERIOR BLOWER) (CONT’D)
Secure the blower by installing 2 more screws into the locations shown in the pictures below (single blower
or dual blower). Reinstall impeller(s) and cover.
Plug the power supply to the 3-prong male connector (A)
and the blower unit into the 2-prong female receptacle
(B) inside the hood.
HE0003
WARNING
Never plug the 2-prong blower cord to the 3-prong power supply cord.
!
FOR DUAL BLOWER UNIT, MAKE
SURE THE IMPELLERS ARE
CORRECTLY INSTALLED, THE
HOOD WILL NOT WORK PROPERLY
IF REVERSED. Both impellers are
different in the dual blower, one
rotates clockwise and the other
counterclockwise. Each wheel and
motor have an arrow and a number
on them, you have to match them
correctly (see drawing beside).
Install screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten
screws down fully, leave a 1/8” gap. Hang blower unit onto blower plate (screws through the large part of
the keyhole). Slide the blower to its position (screws in the small part of the keyhole). Tighten the screws.
HD0044
HD0044
Single blower (P5)
Dual blower (P8)
HD0080
HD0081
Single blower (P5)
FRONT
1
2
A
B
Dual blower (P8)
HD0023