Filter
Top Products
8. INSTALL THE ROUGH-IN PLATE TO THE HOOD (CONT’D)
Wiring
Remove wiring cover from rough-in plate and set aside.
Remove appropriate knockout from rough-in plate. As you are installing the
rough-in plate, feed 6” of power cable through knockout opening and attach
cable to wiring box with appropriate connector.
Connect wires as shown in blower instructions.
Reinstall wiring cover.
WARNING
Risk of electrical shock. Electrical wiring must be done by qualified
personnel in accordance with all applicable codes and standards. Before
connecting wires, switch power off at service panel and lock service
disconnecting means to prevent power from being switched on accidentally.
0
!
Refer to instructions included with blower.
Once the blower is installed, plug the blower unit into the female receptacle and
the power supply onto the male connector inside the hood. DO NOT plug the two
cords into each other.
10. INSTALL BLOWER
HE0003
Install (2) heat lamp bulbs. Use BR40 size, 250W Max., infrared bulbs only
(purchase separately).
Install (3) halogen light bulbs. Use PAR20 50W Size (purchase separately).
11. INSTALL LIGHT BULBS AND WARMING LAMPS
- 9 -
9. INSTALL THE OPTIONAL SOFFIT CHIMNEY
Refer to the instructions included with the soffit chimney.
(OPTIONAL)
RMN Series