Filter
Top Products
32
MOISTURE AND PILOTLESS
ELECTRONIC IGNITION
Ovens, griddle, and grill burners have
a “flame sensing” feature that
automatically stops the sparking once
the pilot gas is ignited. Turning the
control dial ON will activate an
electronic module and send pulses
(sparks) to all electrodes (including
the top burner electrodes) at a rate of
approximately 1 1/2 pulses (sparks)
per second. These controls will be
referred to as OGG (oven, griddle, or
grill).
MOISTURE: Moisture can have the
same effect on the flame sensing
ignitor as does the pilot flame. If
sparking does not occur when an
OGG knob is turned ON during the
initial attempt to use it or after several
days of non-use it COULD BE the
result of moisture build-up in the
ceramic sleeve of the flame sensing
electrode. This may happen in areas
with high humidity. This moisture can
be driven out of the ignitor by
lighting of the OGG pilot and
operating the OGG for a few minutes.
Follow the instructions below for
lighting the pilot.
NEVER LEAVE THE CONTROL
KNOBS IN ANY POSITION
OTHER THAN “OFF” IF THE
IGNITORS OR BURNERS AREN’T
WORKING PROPERLY.
FIRST:
a) With the OGG control OFF
position yourself so you can see the
OGG pilot.
b) Next turn any top burner knob to
the “LITE” position while watching
the OGG flame sensing pilot. This
puts the module which supplies the
sparks for ignition in a manual
position which overrides the “flame
sensing” feature at all electrodes.
Then turn the OGG control on. If the
OGG pilot doesn’t ignite within five
seconds immediately turn all controls
off. If the OGG pilot does ignite, the
burner should ignite within 60
seconds. If not, immediately turn the
controls off and call a serviceman.
If the OGG is working, to determine
if moisture was the problem wait a
few minutes and attempt to light the
OGG by turning the OGG control dial
on. If sparking occurs at the electrode
to ignite the pilot and within sixty
seconds ignites the OGG burner then
moisture build-up was the problem. If
the OGG burner doesn’t ignite within
60 seconds turn the control off and
call the serviceman.
Accessories
Wok Ring – Remove any cast iron
burner grate and replace with wok
ring. Wok not included.
Griddle Cover – Remove stainless steel
griddle cover/work surface when using
griddle. Do not replace until griddle cools.
Service
If your range should fail to operate
check the following:
Is the electrical cord securely inserted
into the electrical outlet?
Is the circuit breaker open, or is a
fuse blown?
Is there gas supply to the range?
If Service Is Required:
Call your dealer or authorized FiveStar
service agency. The name of the
authorized service agency can be
obtained from the dealer or distributor
in your area.
Have the following information readily
available:
Model number
Serial number and type number
Date purchased
Name of dealer from whom
purchased
Clearly describe the problem that
you are having with the range.
If you are unable to obtain the name of
an authorized service agency, or if you
continue to have service problems, call
1-800-251-7224, or write to FiveStar,
P.O. Box 2490, Cleveland, TN 37320.
Repair Parts
When repair parts are needed, contact
the dealer from whom the range was
purchased. In case your range was
purchased from a source other than an
appliance dealer you may prefer to
contact the manufacturer at the
address shown in this manual.
If service requires installation of
parts, use only FiveStar parts to
ensure protections under the warranty.
This manual should remain with the
range for future reference.