Bunn FMD-4 Beverage Dispenser User Manual


 
12
TROUBLESHOOTING (CONT.)
PROBLEM
Dispenser is making unusual
noises
Excess dust
Display not lit
PROBABLE CAUSE
1. Plumbing Lines
2. Water Supply
3. Tank Heater
1. Fan
1. Lamp
2. Lamp Holder
3. Starter - Lamp
4. Ballast
REMEDY
Plumbing lines should not be rest-
ing on the counter top.
(A) The dispenser must be connected
to a cold water line
(B) Water pressure to the dispenser
must not exceed 100 psi (690 kPa).
Install a regulator if necessary to
lower the working pressure to ap-
proximately 50 psi (345 kPa).
Remove and clean lime off the tank
heater. See page 38
Refer to
Service
- Fan for testing
procedures. See page 25
Refer to
Service
- Lamp, see page 29
for lamp replacement.
Refer to
Service
- Lamp Holder for
testing procedures. See page 29
Refer to
Service
- Starter for testing
procedures. See page 30
Refer to
Service
- Ballast for testing
procedures. See page 18
35135 012103