Filter
Top Products
6
TROUBLESHOOTING
A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems
encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic
Technical Service Department.
• Inspection, testing, and repair of electrical equipment should be performed only by qualied service person-
nel.
• All electronic components have 200-240 volt ac and low voltage dc potential on their terminals. Shorting of
terminals or the application of external voltages may result in board failure.
• Intermittent operation of electronic circuit boards is unlikely. Board failure will normally be permanent. If
an intermittent condition is encountered, the cause will likely be a switch contact or a loose connection at a
terminal or crimp.
• Solenoid removal requires interrupting the water supply to the valve. Damage may result if solenoids are
energized for more than ten minutes without a supply of water.
• The use of two wrenches is recommended whenever plumbing ttings are tightened or loosened. This will
help to avoid twists and kinks in the tubing.
• Make certain that all plumbing connections are sealed and electrical connections tight and isolated.
• This dispenser is heated at all times. Keep away from combustibles.
WARNING
• Exercise extreme caution when servicing electrical equipment.
• Disconnect the dispenser from the power source when servicing, except when electrical tests are speci-
fied.
• Follow recommended service procedures.
• Replace all protective shields or safety notices.
PROBLEM
Equipment will not operate.
PROBABLE CAUSE
1. No power or incorrect voltage
2. Overflow protection switch
REMEDY
(A) Check the terminal block for the
correct voltage. It should be 200
to 240 volts ac across the red and
black terminals for 200 to 240 volt
models.
(B) Check circuit breakers or fuses.
Refer to Service - Overflow protec-
tion switch for testing procedures.
See page 16.
10889 091599