Filter
Top Products
6
PROGRAMMING
When power is applied to the dispenser, the display located on the bottom of the main circuit board will show
the revision level of the software for 5 seconds, and then go to (-). While the tank is filling, the display will read
(FIL). When the tank is full the display will return to (-).
INITIAL PROGRAMMING OF THE CONTROL BOARD
1. Before programming any settings into the Control Board, confirm the correct machine selection is entered.
2. Do this by pressing and holding down on the center button until U1 appears on the display (approximately 9-10
seconds). Release the center button. Now, press and release the center button until the display reads U9. The
display will show either A, 6.25, 12.5, 25.0, or H10.
3. The display should be set to A. If it shows anything but A, press and release the right button until it shows A.
4. Press and release the center button once more. The display will show the Software Version, then (-).
You may now proceed with the Level 1 and Level 2 Programming.
LEVEL 1 PROGRAMMING
TANK WATER TEMPERATURE & READY TEMPERATURE SET-UP
1. Press and hold the center button until P1 appears on the display (approximately 3
seconds) then release button. The tank water temperature set point will appear on
thedisplay.Factorydefaultis200°Fformostdispensers,and90°Fforsome.
2. Use the (+) button to increase the temperature set point, and the (-) button to de-
crease the set point.
NOTE:IftheunitisaH5X,settheTankTemperatureto212°F.
3. After the Tank Temperature is entered, press and release the center button once
more. The display will read P2, then show the ready temperature set point. Factory
defaultis195°Fformostdispensers,and85°Fforsome.
4. Press the (+) button to increase the temperature set point, and the (-) button to
decrease the set point.
5. To exit Level 1 Program press and release the center button once more. The display
will show Software version, then (-).
P3747
LEFT
BUTTON
CENTER
BUTTON
RIGHT
BUTTON
10420.1 040309