Filter
Top Products
2
BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY
Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:
1) All equipment other than as specified below: 2 years parts and 1 year labor.
2) Electronic circuit and/or control boards: parts and labor for 3 years.
3) Compressors on refrigeration equipment: 5 years parts and 1 year labor.
4) Grinding burrs on coffee grinding equipment to grind coffee to meet original factory screen sieve analysis: parts and
labor for 3 years or 30,000 pounds of coffee, whichever comes first.
These warranty periods run from the date of installation BUNN warrants that the equipment manufactured by it will
be commercially free of defects in material and workmanship existing at the time of manufacture and appearing within the
applicable warranty period. This warranty does not apply to any equipment, component or part that was not manufactured
by BUNN or that, in BUNN’s judgment, has been affected by misuse, neglect, alteration, improper installation or operation,
improper maintenance or repair, damage or casualty. This warranty is conditioned on the Buyer 1) giving BUNN prompt
notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227,
Springfield, Illinois 62708-3227; 2) if requested by BUNN, shipping the defective equipment prepaid to an authorized BUNN
service location; and 3) receiving prior authorization from BUNN that the defective equipment is under warranty.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR ORAL,
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of BUNN are not authorized to make
modifications to this warranty or to make additional warranties that are binding on BUNN. Accordingly, statements by such
individuals, whether oral or written, do not constitute warranties and should not be relied upon.
If BUNN determines in its sole discretion that the equipment does not conform to the warranty, BUNN, at its exclusive
option while the equipment is under warranty, shall either 1) provide at no charge replacement parts and/or labor (during
the applicable parts and labor warranty periods specified above) to repair the defective components, provided that this
repair is done by a BUNN Authorized Service Representative; or 2) shall replace the equipment or refund the purchase price
for the equipment.
THE BUYER’S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE SALE OF THIS
EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AT BUNN’S SOLE OPTION
AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.
In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales,
loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment,
facilities or services, or any other special, incidental or consequential damages.
Warranty .......................................................................... 2
Introduction .....................................................................3
User Notices .................................................................... 3
Electrical Requirements ................................................... 4
Plumbing Requirements .................................................. 5
Initial Set-up .................................................................... 5
Electrical Hook-up ............................................................ 5
Plumbing Hook-up ........................................................... 5
Setting Dispenser Flow Rate ............................................6
Selecting the Correct Pump Tubing ..................................7
Operating Controls & Interface ........................................ 8
Initial Fill & Heat ...............................................................9
FlavorGard™ Feature ...................................................... 10
Rinse Alarm Feature ....................................................... 10
BIB Empty Lockout Feature ............................................ 11
Brew Temperature Lockout Feature ................................ 11
34766 010407
Programming the Dispenser Flow Rate ..........................12
Loading the Concentrate ................................................ 18
Priming the Concentrate Lines ....................................... 18
Operating the Pull & Hold Dispenser .............................. 19
Operating the Preset Portion Control Dispenser ............ 20
Filling Cambros or other large containers ......................20
Cleaning & Preventive Maintenance ............................... 21
Replacing the Pump Tubing ........................................... 22
Draining the Hot Water................................................... 23
Troubleshooting .............................................................24
Field Calibration of the Concentrate Pumps ................... 29
Dispenser Flow Rate Calibration .................................... 30
Field Calibrating the Hot Water Flow Rate ...................... 30
Field Calibrating the Empty BIB Warning ........................ 31
Schematic Wiring Diagrams ........................................... 32
CONTENTS