Filter
Top Products
Page 7
COFFEE BREWING
1. Begin each brew cycle with a clean empty brew funnel.
2. Insert a BUNN filter into the funnel. (FIG 6)
3. Pour (or grind) fresh coffee into the filter and level the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" switch is on.
7. Momentarily press and release the desired "BREW" switch. The display will read "BREWING" (flashing red
light on Silver Series).
8. After the coffee finishes dripping from the funnel tip, carefully remove the brew funnel and discard the grounds
and filter. Rinse funnel.
40410 092407
FIG 6A
FIG 6
DO NOT USE FAUCET DURING BREW CYCLE!