Filter
Top Products
26
Specifications and designs are subject to change without
any notice or obligation on the part of the manufacturer.
FCC Compliance Statement
is device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) is device may not cause harmful interference, and
(2) is device must accept any interference received, including interference that may cause undesired
operation.
NOTE: is equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. ese limits are designed to provide reasonable protection against
harmful interference in a residential installation.is equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
· Reorient or relocate the receiving antenna.
·
Increase the separation between the equipment and receiver
.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV
technician for help.
Note: e ONIX complies with Part 15 of the FCC interference limits for Class B digital devices
FOR HOME OR OFFICE USE. ese limits are designed to provide reasonable protection
against harmful interference in a residential installation, and are more stringent than “outdoor”
requirements.
e ONIX does not contain any user-serviceable parts. Repairs should only be made by an Authorized Bushnell
repair center. Unauthorized repairs or modifications could result in permanent damage to the equipment, and
will void your warranty and your authority to operate this device under Part 15 regulations.
e shielded interface cable which is provided must be used with the equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.
ONIX400 1LIM QS Guide-Feb08 Revi26 26 2/20/08 8:56:07 PM