Cannon 10525G Electric Pressure Cooker User Manual


 
15
CARE AND CLEANING
Clean the cooker regularly and wipe up spills soon after they occur to prevent
them from becoming burnt on. Never use biological washing powder, caustic
cleaners, harsh abrasives, scouring pads, steam cleaners, aerosol cleaners or oven
chemical cleaners of any kind.
To move the cooker forward, open the door and with both hands positioned under the
roof of the compartment, lift and pull forward. Replace by pushing the cooker
backwards. Check that the cooker is level. Take care to ensure that any floor covering
is not damaged.
OVEN HEAT CLEAN LININGS
The oven roof and side linings are coated with a special enamel which has a
continuous cleaning action. The higher the oven temperature the more effective the
action. In most cases this cleaning operation will proceed during normal cooking.
However, if roasting is done frequently, or high temperatures are not used regularly, it
may be necessary to run the oven empty at Mark 8 for about two hours.
If desirable, they can be wiped with a cloth wrung out in hot soapy water followed by
a clean damp cloth.
REPLACEMENT OF OVEN LIGHT BULB
CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE
REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC
SHOCK
Light bulbs are not covered by the manufacturer’s guarantee.
A new 15W, 300
o
C rated SES bulb can be obtained from your cooker supplier or any
major electrical retailer.
1. Remove the shelves from the oven.
2. Unscrew the lens using a thick cloth to protect your fingers in the unlikely
event of a lens fracture.
3. Unscrew bulb.
4. Fit new bulb and refit lens.