Filter
Top Products
UNPACKING THE COOKER
Unpack the components. Check that the following parts are present.
Grill pan and grid
Baking dish Pan supports (2)
Oven shelves (2) Enamelled discs (4)
Literature
Aluminium burner bodies (4)
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved
carefully.
STABILITY BRACKET
One of the holes in the lower rear panel can be used to
engage a stability bracket. The bracket must be fitted to
the wall behind the cooker. The diagram is a guide to
the correct height at which the bracket should be from
the floor.
CONNECTING TO GAS SUPPLY
The cooker is designed to match the depth of standard
600mm worktops. An adaptor backplate should,
therefore, be fitted within the shaded area shown to
allow the cooker to be pushed fully to the wall. If a
forward facing backplate is used, it must be chased into
the wall.
Connection to the cooker should be made with an approved appliance flexible
connection to BS 669. Hoses connected to the LPG models should be suitable for LPG
and capable of withstanding 50mbars pressure. A length of 0.9 to 1.25m is
recommended. The length of hose chosen should be such that when the
cooker is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are likely to come in
contact with the flexible hose do not exceed 70
o
C.
21
INSTALLATION INSTRUCTIONS
155mm
Floor to top edge
of bracket.
530
300
200
250
250
680
550