Filter
Top Products
e. Now press the P Button. The display will show:
PLACE LARGE CUP / UNDER FROTHER alternating with PRESS P BUTTON.
f. Place a large cup under the steam nozzle. The cup or container should have
a capacity of 12 oz. Press the P Button. The display will read DECALCIFYING /
IN PROGRESS. For the next few minutes the machine will disburse the
cleaning mix in intervals through the steam nozzle into the cup.
(
Important: Do not empty the contents of the cup into the tray).
Then it will disburse the cleaning mix for a few minutes into the internal tray.
The machine will stop and the display will show EMPTY TRAY.
g. Remove the cup and carefully remove the tray and empty the bottom part
and replace. The display will show: DECALCIFYING / IN PROGRESS. The
internal cleaning continues until all the solution in the water tank is used up.
Then the display will show again EMPTY TRAY.
h. Remove the tray, discard the water and replace. Then the display shows:
FILL WATER TANK alternating with PRESS P BUTTON.
i Remove the water tank and rinse a few times and fill with fr
esh water at least
to the 0.5 liter mark and replace.
j. Press the P Button. The display will show: PLACE LARGE CUP / UNDER
FROTHER alternating with PRESS P BUTTON.
k. Place a large cup under the steam nozzle. The cup or container should have
a capacity of 12 oz. and press the P Button. The display will read DECALCI-
FYING / IN PROGRESS. For the next few minutes the machine will disburse
the clean water in intervals through the steam nozzle into the cup. Then it
will disburse the clean water in intervals into the internal tray. At the end of
the cycle the display shows: EMPTY TRAY
l. Remove and empty the cup, then remove the tray and empty. The display
shows: SET P DIAL / TO POS. 1
m.Turn the Program Dial to position 1 and close the door. The display shows:
RINSE MACHINE / PRESS BUTTON.
n. Place a cup underneath the coffee spouts and press the BUTTON (the button
in the center of the Coffee Dial; not the P Button). The machine will run a
rinse cycle and will return to its normal coffee message.
12.5 Clearing for Transport
If you intend to transport the machine or send it to another place you must
CLEAR the C1300 to avoid damage in transit. Please proceed as follows:
a. Turn off machine (display off) and empty water tank and replace.
b. Turn the SW Dial to the steam position (fig. 2b)
c. Place an empty cup underneath the steam nozzle (fig. 7)
d. Push and hold the BUTTON for approx. 4 seconds. The machine will turn on
and the display will show alternating: SYSTEM / EMPTYING and PLEASE
WAIT / HEATING UP.
e. At the same time the machine will push a little bit of water and some steam
into the cup underneath the nozzle. The whole procedure will take less than
20 seconds.
f. Turn the SW dial to 0-position. The machine will turn off (display off).
The next time you turn the machine on the display will show FILL / WATER
TANK. After you filled the water tank the display will show HOT WATER CYCLE
/ NECESSARY (see chapter 7.3).
19