Capresso 158 Espresso Maker User Manual


 
9. Automatic Monitoring Controls
The C1500 has automatic monitoring controls. The display will show when
cleaning, refilling and any other maintenance is necessary. Here are the messages:
PLEASE WAIT / HEATING UP
The C1500 is heating up. Wait until a different message appears.
RINSE MACHINE / PRESS BUTTON
You must push the BUTTON. Hot water pumps through the coffee spouts and
stops by itself. During this procedure the display shows RINSING.
HOT WATER CYCLE NECESSARY
Place a cup underneath the nozzle and turn the SW Dial to the hot water position
(fig. 2c). When the cycle stops, turn the SW Dial back to the 0-position (fig. 2a).
SET STEAM/WATER / DIAL TO ZERO
The SW Dial is either in the steam position (fig. 2b) or in the hot water position
(fig. 2c). Turn the SW Dial to the 0-position (fig. 2a) and the message will go away.
HEATING UP
The ThermoBlock is heating for steaming. Wait until the display reads STEAM
READY / PRESS BUTTON (see chapter 8.3).
TRAY MISSING
The tray is missing or not inserted properly.
TABLET CLEANING
This message will alternate with the regular message. See chapter 12.1.
DECALCIFYING NECESSARY
This message will alternate with the regular message. See chapters 12.2 and 12.3.
EMPTY TRAY
The tray needs to be removed and the contents emptied. As long as this mes-
sage appears all other functions are blocked. See chapter 9.1.
FILL / WATER TANK
There is not enough water in the water tank or the water tank is completely
empty. As long as this message appears all other functions are blocked.
CHANGE FILTER
It is time to replace the Claris Filter Cartridge. See chapters 11 through 11.2.
9.1 Empty Tray
When the display reads EMPTY TRAY all other functions are blocked. Move the
coffee spout up and carefully lift up the tray and pull it out (fig. 16). The tray
has a total of four parts (fig. 1a).
Remove the Used Coffee Container and empty it. This container holds
between 10 and 16 coffee portions, depending how large the used coffee
portions are.
Discard the water in the tray. This water is the result of the ThermoBlock
system: after each brew cycle it forces the remaining water into the tray. This
way you never have any stale water inside the heating system. Clean all
parts and assemble.
Important: Make sure that the used coffee container is placed onto the
supporting tray before inserting the complete tray back into the machine.
Otherwise, used coffee will fall into the tray causing an overflow.
14.