Filter
Top Products
e. At the same time the machine will push a little bit of water and some steam
into the cup underneath the nozzle. The whole procedure will take less than
20 seconds.
f. Turn the SW dial to 0-position. The machine will turn off (display off).
The next time you turn the machine on the display will show FILL / WATER
TANK. After you filled the water tank the display will show HOT WATER CYCLE
/ NECESSARY (see chapter 7.3).
12.5 User Statistics
Turn the Program Dial to position 9. The display will read COUNTER / COFFEES
and it will show you how many coffee brewing cycles the machine has per-
formed in the lower right hand corner. When pushing the P button additional
information can be retrieved:
• COUNTER / DECALCIFYING • COUNTER / T CLEANING (tablet cleaning)
• COUNTER / HOT WATER • COUNTER / STEAM • COUNTER / FILTER
13. Troubleshooting
A. No coffee comes out of the coffee spout.
• Beans in bean container are not feeding properly into the grinder: Stir beans
(see chapter 7.2a.).
• You used ground coffee in the coffee funnel. The coffee was ground too fine:
Use coarser ground coffee.
• No water is transported through the system: If the Claris filter is installed, it
might block the free flow of water. Please proceed as described in chapter
11.1, f. This will free up the Claris filter. Also, remove water container and
check if the connecting valve is free of any dirt or coffee.
• The internal brewing chamber is clogged: Turn the machine off. Wait for a
minute and turn it on again. When the initialization noise stops, place a cup
underneath the coffee spouts and turn the Program Dial to position 4. Push
the P button to run a rinse cycle. If no water comes out of the coffee spouts,
try one or two more times. When water comes out of the coffee spout, the
brewing chamber is de-clogged.
B. The display shows FILL WATER TANK but there is enough water in the tank.
• The low water flotation device (Fig. 4, call out 4) is missing. Normally there is
a small plastic cover over the flotation device. This plastic cover is missing
and the flotation device is probably somewhere in the water container. If you
can find the pieces, insert the flotation device back into the small compart-
ment and attach the small plastic cover.
• If you cannot find the pieces please call customer service. We will send them
to you free of charge!
C. Insufficient Frothed Milk.
• Make sure that all frothXpress parts are completely clean (see video tape
and chapter 8.7).
• Make sure all frothXpress parts are assembled correctly (fig. 3a, 3e) and the
knob sits parallel (fig. 3b).
• The steam nozzle is clogged. Run some hot water through the steam nozzle.
If no water comes out, unscrew the steam nozzle and clean with a paper clip
or a needle. Hardened milk blocks the opening.
• Use another type of milk.
21.