Filter
Top Products
11
fig. 1
fig. 2
fig. 3
Installation
IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY A SUITABLY
QUALIFIED PERSON. WE RECOMMEND THAT YOU SEEK THE HELP
OF ANOTHER INDIVIDUAL WHEN INSTALLING THIS PRODUCT
1. Slide the base unit into the housing ensuring the dimensions are
correct as per figure 1.
2. Fix the base unit in place by attaching the 10 screws in to
the holes as shown in figure 2 and figure 3. If the sides of the
base are not flush with the sides of the housing, then use the
shims provided.
3. Push the runners fully closed on the base unit.
4. Connect the plug to the plug socket. This must be accessible
after the appliance has been installed.
5. Using an appropriate supply pipe, connect one end of the
hose to the threaded inlet of the valve on the dispenser, located
at the rear of the appliance.
6. Insert the flow restrictor between two rubber washers, then
connect the other end of the pipe to the mains water supply
(drinking water only)
7. Insert the appliance into the housing, ensuring that the runners
on the machine are located in the runners on the base unit.
Then slide the appliance fully into the housing.
320 min
320
542