Filter
Top Products
8
Installation
Your extractor can be used to filter and recycle the air within
your kitchen (A), or to extract the air outside (B). When
extracting air to the outside, the unit can be vented as shown
in the diagram below.
To mount your extractor to the
ceiling
1. Firstly, remove the lower section of the support frame,
by removing the screws shown in Fig 4 below, and then
carefully sliding the two sections apart.
2. Using the supplied template, mark the positions of the
3 main fixing holes and the additional fixing hole (X) on
the ceiling.
3. Drill and plug the holes, as required. If screwing
directly to the ceiling joists, plugs may not be required
(See Important note above)
Fig. 4
Fig. 5
Fig. 6