Filter
Top Products
Types of residues Clean with Cleaning advice
Light Cleaning sponge and soft cloth
Wipe over the zone to be cleaned with a sponge and hot
water, and then wipe off with a soft dry cloth.
Accumulated baked-on stains/
dirt, sugar spills or melted plastics
Cleaning sponge or glass scraper
and soft cloth
Wipe over the zone to be cleaned with a sponge and hot
water, using a ceramic scraper to remove any large marks
or stains and then wipe off with a soft dry cloth.
Rings and hard water residues White vinegar and soft cloth
Pour a small amount of warm white vinegar onto the stain,
leave it to stand, and then wipe off with a soft dry cloth.
9 fast frying steaks
Care and Maintenance
Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.
You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and
could erase the control panel markings.
Important:
• Steam cleaners must not be used when cleaning this appliance.
Mains electrical voltage: 230 – 240Vac
Total rated electrical consumption: 6.3 kW
Please note:
The hob is equipped with a safety device that will switch off the zones and flash F on the zone displays if the control keys
are touched for more than ten seconds, for example an object rests over the keys. Once the cause of the error is removed,
the zone displays will stop flashing and the hob will be ready to be switched on again.
If your Hob is not working:
1. Check that the required zone is switched on.
2. Check that the mains supply has not been switched off.
3. Check that the fuse in the spur has not blown.
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
6